Setup and Configuration
Setup Guide
Setting up your enVision K150S device
This section will guide you through the process of getting your enVision K150S device up and running so you can integrate it into your operation.
If you experience problems while assembling or configurating your device, please reach out to us at envisionsupport@phdsolutions.ca
Setting up the enVision K150S
- Assemble the K150S device as described in the Assembly Instructions.
- Plug a live network cable into the RJ45 connector on the back of the device.
- Plug the supplied power adapter into a supported power outlet.
- After approximately 30-45 seconds, the device will display the enVision logo and begin the boot process.
If this is the first time the device is started, you will be prompted to enter a Company Registration Code, which you would have received in your Welcome email and is also available in the enVision Cloud Portal.
Having problems? Check our Troubleshooting Guide for solutions to common issues.
Next Steps
Proceed to the First Time Setup page for detailed instructions on configuring your device.